Do you know how Mucking Loader can prevent heatstroke in summer?

It is understood that high temperature is easy to do harm to the engine, cooling system, hydraulic system, circuit and tire of the slag scraper. Therefore, related prevention work should start from these aspects. For example, engine oil and lubricating oil everywhere need to be replaced with summer oil, and the amount of oil is appropriate; Always check whether there is oil leakage, especially fuel, and replenish it in time. Always check whether the cooling system and fuel system are unobstructed, and timely replace the aging wires, plugs, oil pipes, screws and other parts, and tighten the fuel pipeline regularly to prevent fuel leakage; Always clean up the oil and dust on the engine fuselage to ensure that the engine is "lightly loaded" and has good heat dissipation.

When the equipment is not used for operation, shade should be selected to avoid direct sunlight. Check all parts of the equipment in detail to see if there are any small cracks. If there are any, repair them in time and apply antirust paint to prevent them from being corroded by a large amount of rain in summer.

In addition, when the tire works in high temperature environment in summer, not only the tire wear will be aggravated, but also the tire puncture will be caused by the increase of internal air pressure; Therefore, it is necessary to control the reduction of tire pressure in summer at about 10%. Pay attention to stop halfway and let the tires cool down after a rest.

When the tire is cooled and depressurized, it should be cooled naturally, and cold water should not be poured on the tire, which will cause cracks in the tire and shorten its service life.